Operation of KF94 mask production machine

KF94 masks are designed and produced with consumers' safety and health in mind. They are comfortable to wear and have a generous and fashionable style with a large mask space, which is loved by the majority of beauty lovers, and this mask is produced by the KF94 mask production machine shown below. That KF94 mask production machine it is simple to operate, the following we will talk about.

Matters that must be checked before starting the machine.

1. Turn on the power supply, clear the total counter and conveyor belt counter to zero

2. Turn on the ultrasonic power, and check whether the ultrasonic wave is normal

3. Check whether the body cutter and ear belt scissors are normal, neat and clean

4. Check whether there is foreign matter on the chain, gear and scissors and whether the fan is normal

5. Confirm that the material is finished wearing open the emergency stop shut off, press the power to turn on the machine

Fabric mounting frame + deflector set

KF94 Mask Body Machine

Ear wire welding machine

KF94 mask production machine

Start-up operation matters.

1. will be the body of the ear wire machine, playing machine, control box, all electrical check whether the power supply voltage meets the requirements, whether safe and effective grounding.

2. Check whether the equipment parts are complete, there is no damage, whether the fasteners are a loose phenomenon, and if there should be repaired and tightened.

3. In The installation of raw materials through the guide, the operator will be intact raw materials installed to the location of the corresponding reel and fixed.

4. Air source and temperature, open the air source switch, and set the air pressure and ultrasonic forming parameters according to the standard: air pressure = 0.6 +-0.05MPA, ultrasonic amplitude = 1 ~ 3 sections, ear melting time = 0.1 +-0.02S

5. Load the material on the rotating axis of the fabric frame, connect the fabric to the front embossing wheel group, run at a slow speed, and manually press the start to send it to the front cutting edge group/transition wheel/folding (corner/edge) group/back embossing group, and then cut the edge to the finished piece of material.

6. Send the nose wire through the nose wire transport group to the cutting device, turn on the machine to run at a slow speed until the nose wire enters the correct position of the nose wire fusion wheel normally, and is cut off normally.

7. Dock the ear wire machine, beating machine, and fabric frame, and turn on the power switch

8. Turn on the ultrasonic power supply and check if it is normal

9. Check whether there is any foreign matter on the chain, whether the elasticity is normal, and whether the fan is strong and in good condition

10. Put the ear cord on both sides of the ear cord machine through the feeding wheel, feeding control wheel conduit, and steering wheel fixed on the ear cord head clamp, and pay attention to the line to be smooth.

11. First use the manual operation mode to check whether the corresponding action is correct and whether the output products meet the requirements.

At the end of the above, I believe you have a particular understanding of how to operate the KF94 mask production machine, if you need more detailed operation methods and videos, please contact us, thank you!