What are the skills of mask making machine debugging? -Make you get twice the result with half the effort

In the process of producing masks, the mask making machine will often have some problems, as long as there is a problem is downtime, which will seriously affect the production schedule and reduce production capacity, so how to effectively try to avoid problems, 18 years mask machine manufacturers combined with years of experience summed up some debugging skills, today to share with friends in need:

1、adjust the air pressure: air pressure valve in the workbench plate below, open the door plate of the equipment you can see the air pressure valve. Adjust the pressure according to the actual situation. When some institutions are not synchronized with the action the pressure will be adjusted more. The working air pressure is adjusted within the range of 0.2~0.6MPa.

2、Sound wave test adjustment: (when the equipment is stopped)

1) open the ultrasonic generator power switch, and press the "sound wave test" switch, such as the amplitude monitor indicators rise sharply and more than 100, it means that the frequency is too far from the resonance point, you must adjust the "sound wave adjustment" knob. Eye amplitude display left-hand press the "sound wave test" check switch (do not exceed 3 seconds), right hand rotates the "sound wave adjustment" knob, the amplitude display pointer to the lowest point.

2) adjustment, such as amplitude display indicator is not down, but up, then reverse the direction of rotation of the "tone adjustment" knob. Amplitude monitor indicator reading within 50, the current meter indicator reading below 0.6 A is the best working condition. After adjusting the sound wave tighten the butterfly nut, and close the protective cover.

3) no-load test, such as "overload indicator" is on, which means the equipment has problems. At this time is not allowed to turn on the work, must be shut down to check the reasons, and to remove the fault before turning on work.

3、the cooling fan test: check whether the cooling fan is working properly to ensure that the ultrasonic transducer can work for a long time when working.

4、Check the pneumatic parts：

1) Turn on the power, connect the air circuit, and switch the manual automatic switching switch to manual gear. Open the material tray switch, and check whether the material tray can run quickly and stably and position accurately. After checking, close the material tray switch. Turn on the mask clamping and feeding jig switch, and check whether the mask clamping and feeding jig can operate normally. After checking, close the mask clamping and feeding jig switch. Turn on the collector cylinder switch and check if the collector cylinder is operating normally. Close the collector cylinder switch after checking.

2) Open the side belt fusion switch to see if the side belt press die can be pressed down normally. Open the right switch of the lug belt rotation to see if the right rotating cylinder moves and is in place. Turn on the left switch of ear belt rotation to see if the left rotating cylinder moves and is in place. Turn on the ear belt shear switch and check whether the small cylinder of ear belt shear is working and can reach the designated shear position.

3) Turn on the ear belt rewind switch and check if the ear belt rewinds small cylinder can work normally and can make the ear belt clamp block loose. Turn on the earband fusion switch and check whether the earband press die can work and reach the specified position.

I hope the above debugging skills of the mask making machine will be helpful to you, if you need to know more about debugging, you can contact us!